Can you believe it? The wire saw machine you're seeing now, which has been cutting stones, has been in operation for over eight years and still looks as good as new. How is this possible? After inquiring, I learned that the owner of this wire saw machine pays special attention to machine maintenance. That's why this wire saw machine can still be on the front - line of stone quarrying after such a long time. So, in this video, let's talk about how to maintain a wire saw machine and what points to note during the maintenance. It's all valuable information, so remember to save it if necessary.

Hello, everyone. I'm Oliver Mo, who manufactures and sells wire saws. There are a total of ten points to summarize for the maintenance of wire saw machines.

1. Check the polyurethane tapes: Before starting the machine, check the wear of the polyurethane tapes on the main drive wheel and the guide wheel. If there is significant wear, replace them in time.

2. Inspect the cables: Before starting the machine, check the power cable and control cable on the mobile end. If there are any damages or electric leakage, wrap them up or replace them immediately. When sawing, pay attention to adjusting the position of the cables as the machine moves to prevent the cables from being crushed.

3. Ensure main motor heat - dissipation: Before starting the machine, check if the heat - dissipation cover of the main motor is unobstructed. If it is blocked, clear it immediately to avoid affecting the heat dissipation of the main motor. Prevent cooling water from entering the main motor through the heat - dissipation port and causing a short - circuit.

4. Check the rails: Regularly check the straightness and firmness of the rails. Clean the rail joints regularly and apply grease to prevent rusting.

5. Inspect the guide wheel: Regularly check if the guide wheel rotates flexibly and if the support is firm.

6. Keep the cabinet clean: Keep the door of the wire saw machine cabinet closed to prevent moisture and dust from entering and damaging the electrical equipment. Keep the inside of the control box clean. If the machine is not used for a long time, dry the electrical control box and the mobile operation console.

7. Use appropriate cooling water: Inject cooling water in the direction of the Diamond Wire Saw cutting. The water level should be appropriate. Do not operate the machine without water.

8. Disconnect power and clean: When the sawing work is finished, disconnect the power supply in time and clean the whole machine.

9. Lubricate the power head: Rotate the automatic oil - filling cylinder 1 - 2 turns clockwise every half - month to lubricate the moving parts of the power head and prevent rusting. Refill the hydraulic oil regularly.

10. Check lubrication monthly: Check the lubricating oil level of the turbine in the walking reducer and the lubrication of the main motor and the walking motor every month, and replenish the lubricating oil in time.

Finally, I'm Oliver Mo, who manufactures and sells wire saws. I hope to be your partner on the stone quarrying journey. If you encounter any problems when buying a wire saw, you can contact me privately. See you in the next video.