During the process of using a wire saw machine to cut stone, it is often necessary to shorten the Diamond Wire Saw and then reconnect it. You can refer to the previously published video "Using the Wire Nipper for the Diamond Wire Saw" for specific details. The shortened diamond wire saw is reconnected with a hydraulic clamp. During the pressing process of the hydraulic clamp, there is a small but crucial part, which is the die of the hydraulic clamp.

Problems with Traditional Dies

The dies equipped with traditional hydraulic clamps have insufficient hardness. So, when pressing, the regular hexagon of the die will deform, resulting in poor crimping. During the cutting process of the wire saw machine, the diamond wire saw may come off at the joint.

The Solution: Special Die for Diamond Wire Saws

The solution is to buy a special die for the diamond wire saw. It is cut and made from high - strength steel carefully selected by our wire saw machine manufacturer. It is suitable for all models of hydraulic clamps. It has high hardness and will not deform even after multiple crimping operations. The crimped diamond wire saw is very firm. Even if the wire saw machine runs at its maximum speed, there is no need to worry about the rope coming off at the joint. Its service life is more than 10 times longer than that of ordinary dies. Moreover, it has double - sided openings. If one side is damaged, you can use the other side. One set can serve as two.

Finally, I'm Oliver Mo, who manufactures and sells wire saws. I hope to be your partner on the stone quarrying journey. If you encounter any problems when buying a wire saw, you can contact me privately. See you in the next video.