Before a wire saw machine cuts mountain stone, it is necessary to drill holes first, then thread the rope, and finally put the rope on the machine for cutting. Many bosses who are new to stone quarrying with wire saw machines don't know how to drill holes and thread the rope. In this video, let's talk about this topic.

Hello, everyone. I'm Oliver Mo, who manufactures and sells wire saws. Let's learn about the whole process of hole - drilling and rope - threading before wire saw cutting through an animated short film.

    After preparing the quarrying surface, we determine the part to be quarried. Use a horizontal drill to drill a bottom hole. Other hole - drilling tools such as a down - the - hole drill or an air gun can also be used. After drilling the bottom hole, use a down - the - hole drill or an air gun to drill a vertical hole so that the vertical hole connects with the bottom hole. Then use a horizontal drill to drill another bottom hole so that the two bottom holes are connected, and all three holes are inter - connected. Tie the traction rope to a strong magnet. Use a non - magnetic stick to push the strong magnet and the traction rope to the bottom of the hole. At the other end, insert a magnetic stick into the bottom of the hole to make the strong magnet attract the magnetic stick. Then pull out the non - magnetic stick. Slowly pull out the magnetic stick, being careful to avoid the separation of the strong magnet from the stick. After pulling out the strong magnet and the traction rope, tie the Diamond Wire Saw to the traction rope. Pull out the traction rope from the other end until the traction rope is completely pulled out from the bottom hole. Let the wire saw surround the cutting surface. Place the wire saw machine and put on the wire saw. Then start the machine and cut until the cutting is completed.

    Preparation before vertical surface cutting: Put the strong magnet and the traction rope into the bottom of the hole. Use a magnetic stick in the bottom hole and insert it into the bottom of the hole to make the strong magnet attract it. Slowly pull out the magnetic stick, being careful to avoid the separation of the strong magnet from the stick. After pulling out the strong magnet and the stick, pull out the traction rope from the other end until the traction rope is completely pulled out from the bottom hole. Let the diamond wire saw surround the cutting surface. Place the wire saw machine and put on the wire saw. Then start the machine and cut until the cutting is completed. Use the same method to cut the other vertical surface. Then move away the cut stone. The quarrying is completed!

    Finally, I'm Oliver Mo, who manufactures and sells wire saws. I hope to be your partner on the stone - quarrying journey. If you encounter any problems when buying a wire saw machine, you can contact me privately. See you in the next video.